Sensor Systems for Environmental Monitoring Volume Two: Environmental Monitoring
Main Author: | |
---|---|
Format: | eBook |
Language: | English |
Published: |
Dordrecht
Springer Netherlands
1997, 1997
|
Edition: | 1st ed. 1997 |
Subjects: | |
Online Access: | |
Collection: | Springer Book Archives -2004 - Collection details see MPG.ReNa |
Table of Contents:
- Volume
- 1 Land pollution
- 1.1 Introduction
- 1.2 Common contaminant types and environmental behavior
- 1.3 Sampling and analytical procedures
- 1.4 Monitoring equipment and instrumentation
- 1.5 Summary
- References
- 2 Water pollution
- 2.1 Introduction
- 2.2 Sampling
- 2.3 Continuous monitoring
- 2.4 Physical variables
- 2.5 Chemical variables
- 2.6 Biological variables
- 2.7 Conclusions -
- Acknowledgements
- References
- 3 Air pollution
- 3.1 Introduction
- 3.2 Characterisation of atmospheric pollutants
- 3.3 Air pollution sampling
- 3.4 Monitoring modes
- 3.5 Conclusions
- References
- 4 Periodic methods for monitoring air pollution
- 4.1 Introduction
- 4.2 Sampling: the problems to overcome
- 4.3 Losses to the sample line
- 4.4 Classification of pollutants
- 4.5 Classification of air samplers
- 4.6 Detection limit
- 4.7 Gas velocity and total flow in a duct
- 4.8 Measurement of particulate in ducts
- 6 Noise and vibration
- 6.1 Introduction
- 6.2 Noise sources
- 6.3 Legislation
- 6.4 Measurement
- 6.5 Noise reduction and control
- 6.6 Future trends
- 6.7 Glossary
- References
- 7 Ionising radiation
- 7.1 Introduction to radiation
- 7.2 Properties of ionising radiation
- 7.3 Sources of ionising radiation
- 7.4 In situ measurements
- 7.5 Sampling
- 7.6 Analytical procedures
- 7.7 Case study
- 7.8 Conclusions
- References
- 4.9 Sampling devices for non-reactive gases and vapours
- 4.10 Wet impingers and sintered glass absorbers
- 4.11 Cryogenic methods
- 4.12 Odour measurement
- 4.13 Instrumental methods for use in the field
- 4.14 Standard atmospheres
- 4.15 Selected methods
- 4.16 Conclusion
- Acknowledgements
- Appendix 1: References to the Environmental Protection Agency of the USA
- Appendix 2: References to the NIOSH methods
- Appendix 3: References to the Health and Safety Executive methods for the determination of hazardous substances (HSE MDHS)
- Appendix 4: References to the ASTM standard methods
- References
- 5 Industrial methods of spectrophotometry measurements in process control
- 5.1 Introduction to process analytical chemistry
- 5.2 Project route
- 5.3 Industrial uses of spectroscopy
- 5.4 Industrial measurements in the UV-visible region
- 5.5 Industrial measurements in the IR region
- 5.6 Quantitative measurement in spectroscopy
- 5.7 Future trends
- References